Wellsystem Relax Instructions De Service page 40

Faults
Error Meaning
Drive motor: Electronic/Mechan-
ical defect
Parameters cannot be set up for
the motor control card.
Drive motor: Electronic/Mechan-
ical defect
Chip card: Card was put in
wrongly or is no longer valid.
Programmable chip card: Empty
card has been put in (no mas-
sage program stored on it); card
might be defective.
Correction
Disconnect the unit, wait one (1) minute and reconnect.
230 V
1 min
Press START/STOP to reset the error display.
Disconnect the unit, wait one (1) minute and reconnect.
230 V
1 min
Put the card in correctly or use the correct card.
Load a program on the card or change cards.
230 V
230 V
39