Water Temperature; Starting A Massage - Wellsystem Relax Instructions De Service

Operating instructions

Water temperature

After connecting, it takes approximately eight
(8) hours for the unit to reach operating temper-
ature.
The water temperature is preset to 95°F /
35°C. Change the preset – see Page 32.
Note:
If there is a fault and the tempera-
ture rises to 113°F / 45°C or falls
below 68°F / 20°C, a fault code is
displayed – see Page 37.
WARNING – risk of hyperther-
mia!
– Do not use the system if fault
WARNING!
codes are displayed.
1
>39 °F / >4 °C
+ 8 hours
2
~95 °F / ~35 °C

Starting a massage

"ON"
Note:
If and how the massage time can
be selected depends on the de-
fault settings – see Page 32.
– Set up the massage time – see Page 21.
– Lay down on the unit.
– Select the type of massage you want (see
Page 21) and then press the start
button .
– Adjust the massage pressure to your wish-
es – see Page 21.
35010 / 0
Note:
During operation, the fan in the
bottom part of the unit is switched
on and off automatically.
30300 / 0
19