Refilling The Tank; Refill With Water - Wellsystem Relax Instructions De Service

User maintenance and care

Refilling the tank

If there has been significant loss of water (pud-
dles on the floor!), please get in touch with the
Global Service Division – see Page 3.
If you want to fill up the tank, proceed as fol-
lows:
CAUTION – you can damage
the system!
Do not overfill with water! If the
tank is overfilled, water can pene-
trate the inside of the system.
This can damage the system.
The pressure from the water feed
must not exceed 8 bar.
28
1
1
1. Remove the front panel
The front panel is suspended in the frame at
two (2) points at the bottom and four (4) points
at the top –see Fig. 1.
– Use a cross-head screwdriver to push
down the top hooks carefully and then
push the front panel upwards with your
other hand to unhook it.
– Remove the front panel by pulling it for-
wards.
2
2
35118 / 0

2. Refill with water

– Use gloves.
– Place a hose (1/2") with a suitable connec-
tor (e.g. Gardena) on the pipe .
– Open the cock .
– Open the water feed.
– Open the valve
up and down on the rubber blanket whether
water is already coming from the valve
– When sufficient water has been added,
close the cock and remove the hose.
5
3
4
35121 / 0
and check by pressing