Connecting The Differential Switch To The Kit - Balboa TP600 Manuel D'utilisation

INSTALLATION
Check that the differential switch is in the OFF position. Do not place the differential switch in the
ON position until the Spa is full of water.
OFF ON
GREEN RED

2.3.2. Connecting the differential switch to the Kit

Before doing any work on the kit, the electrical power supply should be switched off (differential
switch in the OFF position, or disconnect the cable from the mains).
Use appropriate cable from the differential switch to the electrical cabinet of the kit, depending on
the type of location where the kit is to be installed, and current applicable law. The cable section
will be different depending on the model of kit and the distance of the installation.
High Amp / Low Amp Configuration
Depending on the configuration of the kit, the consumption of electricity can vary considerably,
and as a result, the installation should match the electric power required.
LOW AMP:
This configuration disconnects the electric heater when any massage pump is started-up. This
configuration limits the electricity consumption.
NOTE: LOW AMP is the standard default configuration.
10 Compact Kit for private use - Operating Instructions