Balboa TP600 Manuel D'utilisation page 35

ERROR MESSAGES
Program memory
At Power-Up, the system has failed the
Program Checksum Test.
failure – M022
The settings
have been reset
(Persistent Memory
Error) – M021
The clock has failed
– M020
Configuration error
(Spa will not Start
Up)
A pump may be
Water may be overheated.
stuck on – M034
Hot fault – M035 A Pump Appears to have been Stuck
ON when spa was last powered POWER
DOWN THE SPA.
** Some messages can be reset from the panel. Messages that can be reset will appear with a Clear
Icon at the bottom of the Message Screen. Press the Clear Icon text to reset the message.
REMINDER MESSAGES
General maintenance helps: Reminder Messages can be suppressed by using the Reminders
Screen. Reminder Messages can be chosen individually by the Manufacturer.
Check the pH : May appear on a regular schedule, i.e. every 7 days. Check pH with a test kit and
adjust pH with the appropriate chemicals.
Check the sanitizer: May appear on a regular schedule, i.e. every 7 days. Check sanitizer level
and other water chemistry with a test kit and adjust with the appropriate chemicals.
Clean the filter: May appear on a regular schedule, i.e. every 30 days. Clean the filter media as
instructed by the manufacturer.
Change the water: May appear on a regular schedule. Change the water in the spa on regular
basis to maintain proper chemical balance and sanitary conditions.
Clean the cover: May appear on a regular schedule.Vinyl covers should be cleaned and
conditioned for maximum life.
Treat the wood: May appear on a regular schedule. Wood skirting and furniture should be
cleaned and conditioned per the manufacturers instructions for maximum life.
Change the filter: May appear on a regular schedule. Filters should be replaced occasionally to
maintain proper spa function and sanitary conditions.
Change the UV / Check the ozone: May appear on a regular schedule.
This indicates a problem with the firmware (operation
program) and requires a service call.
See: **.
Contact your service organization if this message
appears on more than one power-up.
See: **.
If the problem persists, contact your vendor or a
service engineer.
See: **.
If the problem persists, contact your vendor or a
service engineer.
POWER DOWN THE SPA. DO NOT ENTER THE WATER.
Contact your dealer or service organization.
DO NOT ENTER THE WATER.
If the problem persists, contact your vendor or a
service engineer.
ENG
35