Balboa TP600 Manuel D'utilisation page 28

HOW TO USE YOUR SPA
Each range maintains its own set temperature as programmed by the user. This way, when a
range is chosen, the spa will heat to the set temperature associated with that range.
High Range can be set between 80°F and 104°F/ 27 ºC and 40 ºC.
Low Range can be set between 50°F and 99°F / 10 ºC and 37 ºC.
Freeze Protection is active in either range.
Heat Mode – Ready vs. Rest
In order for the spa to heat, a pump needs to circulate water through the heater. The pump that
performs this function is known as the "heater pump".
The heater pump can be either a 2-speed pump (Pump 1) or a circulation pump.
Rest Mode will only allow heating during programmed filter cycles. Since polling does not occur,
the temperature display may not show a current temperature until the heater pump has been
running for a minute or two.
Circulation Mode
If the spa is configured for 24HR circulation, the heater pump generally runs continuously. Since
the heater pump is always running, the spa will maintain set temperature and heat as needed in
Ready Mode, without polling.
In Rest Mode, the spa will only heat to set temperature during programmed filter times, even
though the water is being filtered constantly when in 24HR circulation mode.
Ready-in-Rest Mode
Ready in Rest Mode appears in the display if the spa is in Rest Mode and the Jets 1 Button is
pressed. After 1 hour, the System will revert to Rest Mode. This mode can also be reset by selecting
the Heat Mode line on the Screen shown here.
ADJUSTING FILTRATION
Main Filtration
Using the same adjustment as Setting the Time, Filter Cycles are set using a start time and a
duration. Each setting can be adjusted in 15-minute increments. The panel calculates the end time
and displays it automatically.
The Filter Icon on the Settings Screen takes you to a screen where you control the Filter
Cycles.
Filter Cycle 2 - Optional Filtration
Filter Cycle 2 is OFF by default. Press "1" to view Filter 1. Press "2" once to view Filter 2. Press "2"
again to turn Filter 2 ON or OFF. When Filter Cycle 2 is ON, it can be adjusted in the same manner
as Filter Cycle 1. It is possible to overlap Filter Cycle 1 and Filter Cycle 2, which will shorten overall
filtration by the overlap amount.
Purge Cycles
In order to maintain sanitary conditions, as well as protect against freezing, secondary water
devices will purge water from their respective plumbing by running briefly at the beginning of
each filter cycle. (Some systems will run a certain number of purge cycles per day, independent of
the number of filter cycles per day. In this case, the purge cycles may not coincide with the start
28 Compact Kit for private use - Operating Instructions