Assembly Of The Equipment - Balboa TP600 Manuel D'utilisation

INSTALLATION

2.2. ASSEMBLY OF THE EQUIPMENT

The following type of piping should be used for the connection:
Filtering circuit: PN 10 diameter 50 mm*
Massage circuit (jets): PN 10 diameter 63 mm*
Air massage circuit: PN 10 diameter 50 mm*
*On standard distance (maximums 7 m) and without losing power charge.
Follow the diagrams and assembly instructions given below for each circuit.
In any event, the installation of bends and piping should be reduced to a minimum in order to
reduce the load loss of the installation.
Always use plastic accessories, gasket and teflon tape for the selector valve connections. Never use
steel accessories or piping as they could seriously damage the plastic components.
Detail of circuits
Filtering Circuit
Connect the suction circuit of the filtering pump to the outlet of the Spa Skimmer, placing two ball
valves to stop the water flow if necessary.
Connect the filtering return, the heater outlet, to the impulse inlet of the Spa, placing two ball
valves to stop the water flow if necessary.
6 Compact Kit for private use - Operating Instructions