Chapter 4: The Tape Player; Playing A Tape - Sony MHC-G99AV Mode D'emploi

Chapter 4:
the Tape
Player

Playing a Tape

Recording a CD
Recording a CD: Selecting
Tape Length (tape select
edit)
Recording a CD: Specifying
Tape Length (time edit)
Recording a CD: Specifying
EN
Track Order (program
edit)
14
Recording From the Radio
Recording From Another
Tape (dubbing)

Chapter 4: the Tape Player

Playing a Tape
You can use TYPE I (normal), TYPE II
(CrO ) and TYPE IV (metal) tapes. When
2
you insert a tape, the deck detects the tape
type automatically.
POWER n ON
º/‚
2
1
π π
∏PAUSE
DOLBY NR DIRECTION
1
Press § EJECT to open tape
compartment.
Insert a recorded tape in deck A or B
with the tape side down and the side
you want to play facing forward. Push
to close the compartment.
2
Press · (to play the front side) or ª
(to play the reverse side).
The tape starts playing.
To play Press DIRECTION
to select
One side of the tape A
1 ß
Both sides*
Both decks in RELAY
succession* 2
* 1 The deck stops automatically after
repeating the sequence five times.
* 2 See "To play both decks in succession
(relay play)".
To Press
π (p*)
Stop play
Pause ∏ PAUSE (P*) (Deck B only)
Resume ∏ PAUSE (P*) (Deck B only),
play after ª or · (DECK A ª· or
pause DECK B ª·*)
‚ ()*) for front side
Fast
º (0*) for reverse side
forward
Rewind º (0*) for front side
‚ ()*) for reverse side
Remove the § EJECT
cassette
* Remote
To control with the remote
1 Press DECK A ª· or DECK B ª·
to play the front side and press
DECK A ª· or DECK B ª· again
to play the reverse side.
2 Press the desired operation button.
To play both decks in succession
(relay play)
Relay play always follows the following
sequence. When the reverse side of the tape
in deck B finishes playing, the following
sequence continues four more times.
Deck A
(Front side)
2
Deck B
1
(Reverse side)
1 Press § EJECT and insert recorded tapes
in both decks.
2 Press DIRECTION repeatedly until
"RELAY" appears in the display.
3 Press ª or · on either deck.
To stop relay play, press π.
To cancel relay play
Press DIRECTION repeatedly until "A"
or "ß" appears in the display.
When listening to a tape recorded with the
Dolby* B-type noise reduction system
Press DOLBY NR button so that "DOLBY
NR B" appears in the display.
The setting affects both decks. Dolby noise
reduction system reduces tape hiss noise in
low-level high-frequency signals.
* Dolby noise reduction manufactured
under license from Dolby Laboratories
Licensing Corporation.
"DOLBY" and the double-D symbol a
are trademarks of Dolby Laboratories
Licensing Corporation.
One Touch Play feature
Press · or ª when the power is off.
You can listen to the tape without pressing
any other buttons when a tape is in the
deck. When a tape is not in the deck, the
system will just turn on.
Automatic Source Selection
If you press · or ª (or DECK A ª·
or DECK B ª· on the remote) while you
are listening to other sound source, the tape
deck is selected and the play starts
automatically.
Deck A
n
(Reverse side)
Deck B
N
(Front side)