Technoline WS6442 Mode D'emploi page 12

Notes:

If the outdoor temperature is not displayed after 3 minutes, hold the "CHANNEL" button on the main unit to search for outdoor sensor.
Then press the TX button on the sensor to send signal. If it still does not receive the outdoor temperature, remove the batteries from the
transmitter and go back to step 1 of the set up.

Extended periods of cold temperature (below-20°C) can cause alkaline batteries to function improperly. This will cause the outdoor
wireless sensor to stop transmitting temperature readings. Use lithium batteries in these low temperature conditions to ensure continued
operation for wireless sensors placed outdoors.

Place the outdoor sensor in a dry and shady area.
Reception of the radio-controlled time signal:

The clock automatically starts the DCF signal search after 7 minutes of any restart or changing of new fresh batteries. The radio mast icon
starts to flash.

At 1:00 / 2:00 / 3:00 / 4:00 / 5:00 the clock automatically starts the synchronization procedure with the DCF signal to correct any deviations
to the exact time. If this synchronization attempt is unsuccessful (the radio mast icon disappears from the display), the system will
automatically attempt another synchronization at the next full one hour. This procedure is repeated automatically up to total 5 times.

To start manual DCF signal reception, press the "SET/RCC" button. If no signals received within 7 minutes, then the DCF signal search
stops (the radio mast icon disappears) and start again at the next full one hour.

During RC reception，to stop searching radio signal, press the "SET/RCC" button once.
Notes:

A flashing radio mast icon indicates that the DCF signal reception has started

A continuously displayed radio mast icon indicates that the DCF signal was received successfully

We recommend a minimum distance of 2.5 meters to all sources of interference, such as televisions or computer monitors

Radio reception is weaker in rooms with concrete walls (e.g.: in cellars) and in offices. In such circumstances, place the system close to
the window.
Manual time setting
Press and hold SET/RCC button to enter setting mode:

24/12-HOUR: 24Hr will flash. Press the +/HEAT/DEW or -/MAX/MIN button to select the 24-hour or 12-hour time. Press the SET/RCC
button to continue.

Time zone: Time zone will be displayed and the selected time zone will flash. Press the +/HEAT/DEW or -/MAX/MIN button to set the
desired time zone ( setting range is 0~+12,0~-12). +0 for Germany, +1 for UK. Press and release the SET/RCC button to continue.

HOURS: The hours will flash. Press the+/HEAT/DEW or -/MAX/MIN button to select the hours. Press the SET/RCC button to continue.

MINUTES: The minutes will flash. Press the +/HEAT/DEW or -/MAX/MIN button to select the minutes. Press the SET/RCC button to
continue.

YEAR: The year will flash. Press the +/HEAT/DEW or -/MAX/MIN button to select the year. Press the SET/RCC button to continue.

MONTH: The month will flash. Press the +/HEAT/DEW or -/MAX/MIN button to select the month. Press the SET/RCC button to continue.
EN3