Hazard And Warning Information; General Information; Specific Instructions; Authorized Persons - Renfert MT3 Guide De Démarrage

Hazard and Warning Information

en

General Information

► If the device is not used in compliance with the supplied instructions, the safety of the device can
no longer be guaranteed.
► Risk of injury!
Risk of injury if the components used are not approved.
Always use original Renfert components.
► The device may only be operated using a mains cable with the country-specific plug system. Any
necessary alterations must be carried out by a qualified electrician.
► The device may only be operated if the information on the identification plate conforms to the
specifications of your local mains power supply.
► The device may only be plugged into outlets which are connected to the protective conductor
system.
► The mains plug must be easily accessible.
► Disconnect the device from the mains before carrying out work on the electrical parts.
► It is the responsibility of the operator that national regulations during operation and regarding
a repeated safety inspection of electrical equipment are complied with. For Germany these are
the regulation 3 by DGUV (German Statutory Accident Insurance) in relation with VDE 0701-0702
(Association for Electrical, Electronic and Information Technology).
► Check connection cables (such as power supply cords), tubes and housing (i.e. the key-pad) regu-
larly for damage (i.e. kinks, cracks and porosity) or signs of ageing.
Devices with damaged connection cables, tubes or housing parts or other defects must not be
operated!
► Defective devices must be put out of service immediately. Remove the mains plug and ensure the
device is not used. Send the device for repair!
► Only operate the device under supervision.
► Please observe the national accident prevention regulations!

Specific Instructions

► Never reach into the grinding wheel while the unit is connected to the power supply.
Inadvertently starting the unit can result in injury!
► Always keep long hair, loose or wide sleeves or other clothing away from the trimmer. Hair or
clothing can be pulled into and wrapped up on the grinding wheel, resulting in injury!
► The unit is designed solely for grinding plaster models. Cancer causing dusts are released when
trimming investment material.
► Never open the front cover while the motor is running. The motor safety shutoff will not stop the
grinding wheel immediately.
► Only open the front cover after the grinding wheel has come to a complete stop.
► Always wear protective eyewear when grinding.
► Do not reach into the grinding wheel while it is turning.
► Do not work without the model table installed and locked („click"). Small parts or fingers can be
drawn into the trimmer, resulting in serious injury.
► Remove the trimmer table only after the grinding wheel has come to a complete stop and the front
cover is opened.
► The extraction must be selected to match the dust being generated (if necessary, consult the re-
sponsible professional organization).
► Operating the unit can result in a very high noise level >>> always wear ear protection.

Authorized Persons

Operation and maintenance of the device may only be performed by qualified personnel.
- 2 -