Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1
Introduction
We are pleased with your decision to purchase a Waxprofi denture wax heating unit.
Please observe the following information in order to ensure long and trouble-free service.
2
Application Area
The Waxprofi wax heating unit is used to heat base waxes to their ideal processing temperature for full
and partial dentures.
In the large pot, the wax is held at a liquid, viscous, or spreadable consistency, as required, ready for fur-
ther processing with the preheated wax knife and Bunsen burner or an electronic waxing-up instrument.
2.1
Ambient Conditions
(in accordance with IEC 60664-1)
The Waxprofi may only be operated:
• Indoors.
• Up to an altitude of 2,000 m (6,500 ft) above sea level.
• At an ambient temperature of 5 – 40 °C (41 – 104 °F).
• At a maximum relative humidity of 80 % at 31 °C (87.8 °F), decreasing linearly to 50 %
relative humidity at 40 °C (104 °F).
• With a mains power supply where current fluctuations do not exceed 10 % of the nominal value.
• Under Level 2 contamination conditions.
• Under overvoltage category II conditions.
3
Safety Information
3.1
Symbols Used
The following symbols are employed in these instructions and on the unit:
Danger
An imminent danger of injury exists.
Electrical Power
Danger of electrical shock.
Attention
Failure to observe this information can result in damage to the unit.
Note
This is a note intended to provide the operator with useful information to make operation easier.
For indoor use only.
Before opening the unit, disconnect it from the power supply by pulling the wall plug.
3.2
Safety Information
► The Waxprofi is an electrical device with potential hazards. This unit may only be locked and used
by authorized specialist personnel after an examination with regard to conformity with applicable
national standards.
► Before starting the unit, compare the voltage information on the nameplate with the specifications
of your local power supply.
► Units with damaged power cords or other defects may not be operated.
► During operation, always unroll the power cord (overheating hazard in case of a short circuit).
► Liquid waxes can cause burns. Never move the unit while it is operating!
► During operation, the wax pot are heated up to its rim. Improper use or handling can result in
burns (for up to 30 min. after the unit is switched off).
► The Waxprofi is designed to be used exclusively in conjunction with commercially available dental
waxes. Never use the unit to heat other types of materials!
► Please note: Overfilled pots can overflow!
► Materials whose flash point is under 175 °C (347 °F) may not be stored in proximity to the
Waxprofi or come in contact with the Waxprofi.
► Never rinse the unit with water or submerge it. The mains power will result in electric shock!
- 1 -
EN
Publicité
Table des Matières
