General Information; Electrical Safety - Astralpool MULTI-PARAMETRIC INSTRUMENT Manuel D'installation

GENERAL INFORMATION

1
1.1 INFORMATION REGARDING THE MANUAL
This document contains confidential information. This information may be subject to modifications and updates
without any prior notice.
This manual is an integral part of the instrument. At the time of the device's first installation, the operator must
carefully check the contents of the manual in order to verify its integrity and completeness.
In order to guarantee the device's proper functionality and operator safety, it is fundamental that the operative
procedures and precautions described in this manual be respected.
Before using the device, the manual must be read in all of its parts, in the presence of the device itself, in order to
ensure that the operating modes, the controls, the connections to the peripheral equipment and the precautions for
safe and correct use are clearly understood.
The user manual must be stored, integral and legible in all parts, in a safe place which can be quickly and easily
accessed by the operator during installation, use and/or installation revision operations.
1.2 LIMITATIONS OF USE AND SAFETY PRECAUTIONS
In order to guarantee operator safety and correct device functionality, all of the usage limitations and precautions
listed below must be respected:
ATTENTION: Make sure that all the safety requirements have been met before using the device. The device must
not be powered on or connected to other devices until all of the safety conditions have been met.
1.3

ELECTRICAL SAFETY

ATTENTION: All of the control unit's connections are isolated from the grounding system (non-insulated grounding
conductor).
DO NOT connect any of these connections to the grounding connector.
In order to guarantee maximum conditions of safety for the operator, it is recommended to follow all of the
indications listed in this manual.
• Only power the device using a mains power supply that complies with the device's specifications (85-
265Vac 50/60Hz)
•
Replace any damaged parts immediately. Any cables, connectors, accessories or other parts of the device
which are damaged or not functioning properly must be replaced immediately. In such cases, contact your nearest
authorized technical assistance centre.
•
Only use specified accessories and peripherals. In order to guarantee all of the safety requirements, the device
must only be utilized in conjunction with the accessories specified in this manual, which have been tested for use
with the device itself.
1.4 SAFETY OF THE OPERATING ENVIRONMENT
•
The instrument is resistant to liquids. The device must be protected against drips, sprays and/or immersion and
should not be used in environments where such risks are present. Any devices into which liquids may have
accidentally penetrated must be immediately shut off, cleaned and inspected by authorised and qualified
personnel.
• If present, the transparent panel should be closed once the device has been programmed.
0000137242 Rev.3.1 2