Astralpool MULTI-PARAMETRIC INSTRUMENT Manuel D'installation page 10

3.0 SETTINGS AND FUNCTIONALITY
3.1 INSTRUMENT DISPLAY
12:30
pH 7.20 pH
CL 1.50 ppm
ORP 750 mV
The right/left keys can be used to select display modes A and B
Note: Any unavailable chemical measurements will not be displayed.
Mode A
Line 1 = Time; system water flow status
Line 2 = pH measurement display; Temperature measurement display.
Line 3 = Chlorine display; Network connection through RS485 serial port (
Line 4 = ORP (Redox) display; Hold signal or OFA alarm flashing display, Available Alarms list display.
Mode B
Line 1 = pH dosing pump status, pH measurement display, Hold signal or OFA alarm flashing display.
Line 2 = Chlorine dosing pump status, Chlorine measurement display
Line 3 = ORP (Redox) dosing pump status, ORP (Redox) measurement display
Line 4 = Temperature relay status,Temperature measurement display; Available Alarms list display.
3.2 INSTRUMENT KEYBOARD
Esc/Mode = Dual function key
Esc= Exits the menu
Mode= Displays the measurement SetPoints (hold down for 3 seconds)
Cal = Accesses the calibration menu (hold down for 3 seconds)
Enter = Confirms the function, Displays the alarms list (hold down for 3 seconds)
Esc+Enter = Key combination for accessing the programming menu (hold down for 3 seconds)
Navigation keys= Up, Down, Right, Left for selecting parameters and navigating the menus
A
FLOW ON
Tm 25.0°C
Hold A
0000137242
P ON pH
P ON CL
P OFF ORP
R ON T
symbol)
Rev.3.1
B
7.40 pH Hold
0.80 ppm
700 mV
25.0°C A
8