Graco GLIDER ELITE Manuel D'instructions page 7

{EN WARNING}
Discard leaky batteries immediately. Leaky batteries
can cause skin burns or other personal injury. When
discarding batteries, be sure to dispose of them in
the proper manner, according to the state and local
regulations.
Always remove batteries if the product is not going to
be used for a month or more. Batteries left in the unit
may leak and cause damage.
Recommended type batteries - alkaline disposables.
NEVER mix battery types. Change batteries when
product ceases to operate satisfactorily.
Non-rechargeable batteries are not to be
recharged
WARNING: Use only power cord provided. Transformers
used with the product are to be regularly examined for
damage to the cord, plug, enclosure and other parts,
and in the event of such damage, they must not be
used until the damage has been repaired.
CARE & MAINTENANCE}
{EN
FROM TIME TO TIME CHECK YOUR PRODUCT for loose
screws, worn parts, torn material or stitching.
Replace or repair the parts as needed. Use only Graco
replacement parts.
REMOVABLE CLOTH SEAT COVER may be machine
washed in cold water on delicate cycle and drip-dried.
NO BLEACH.
PROBLEM SOLVING}
{EN
Product won't operate:
1. No batteries in swing.
2. Batteries dead.
3. Speed setting too low.
4. Batteries in backwards - check „+" and „-".
5. Corrosion on battery terminals. Rotate batteries in
place against terminals, or clean with sandpaper or
steel wool if corrosion is severe.
6. Baby leaning far too forward.
7. Baby grabbing swing legs. (Discontinue use).
8. Seat not pushed high enough for a good start.
9. Protective device activated. (Turn off motor, wait 3
minutes, then restart swing).
Transformers or batteries: Product is not to be
connected to more than the recommended number
of power supplies.
The product must only be used with the
recommended transformer.
The transformer is not a toy.
Only use the recommended AC Adaptor supplied with
the product. Only plug the AC Adaptor into a single
outlet.
The crossed out wheelie bin symbol
indicates the product is to be recycled.
TO CLEAN FRAME, use only household soap and warm
water.
NO BLEACH or detergent.
Excessive exposure to sun or heat could cause fading
or warping of parts.
Seat doesn't swing very high:
1. Control setting too low.
2. Blanket hanging down, causing increased wind
resistance.
3. Batteries too weak.
4. Baby leaning too far forward.
5. Baby too heavy or too active. (Discontinue use).
6. Soft carpet (swing higher on hard floors).
12
{EN INSTRUCTIONS}
Assembly – see page 3, images 1, 2, 3
Attaching Bouncer Legs – see page 4, images 4, 5
Attaching Seat Pad – see page 4, 5, images 6, 7, 8, 9
Frame Assembly – see page 5, images 10, 11
Attaching Swing Arms – see page 6, images 12, 13, 14
Attaching Hanger Tubes – see page 7, images 15, 16
Attach Cover – see page 7, image 17
Attach Carrier – see page 8, image 18
Handle – see page 8, image 19
Canopy – see page 8, images 20, 21, 22
Head Support – see page 9, image 23
Body Support – see page 9, image 24
Recline – see page 9, images 25, 26
To Secure Child – see page 9, images 27, 28, 29, 30, 31
Installing Batteries – see page 10, image 32
AC Adapter – see page 10, image 33
Starting Swing – see page 10, images 34, 35, 36, 37, 38,
39, 40, 41
Vibration – see page 10, image 42
13