Safety First; General Information - Pentair BERKELEY B85580 Manuel Du Propriétaire

General Safety
Do not allow pump, piping, or any other system
component containing water to freeze. Freezing may
damage system, leading to injury or flooding. Allowing
pump or system components to freeze will void
warranty.
Pump approved liquids only with this pump.
Periodically inspect pump and system components.
Wear safety glasses at all times when working on
pumps.
Keep work area clean, uncluttered and properly lighted;
store properly all unused tools and equipment.
Keep visitors at a safe distance from the work areas.
Electrical Safety
WARNING
Hazardous voltage.
Can shock, burn, or
cause death.
Ground pump before
connecting to power
supply.
BE839

Safety First

General Information

Pump Location
WARNING
Rotating parts. Can catch
hands, feet, or clothing.
Stay clear of equipment and
keep shields in place while
pump is running.
Stop motor or engine before
servicing pump.
Read owner's manual before
using equipment.
Wire motor for correct
voltage. See "Electrical"
section of this manual
and motor nameplate.
Ground motor before
connecting to power
supply.
Meet National Electrical
Code and local codes
for all wiring.
Follow wiring
instructions in
this manual when
connecting motor to
power lines.
READ AND FOLLOW
SAFETY INSTRUCTIONS!
This is the safety alert symbol. When you see
this symbol on your pump or in this manual, look
for one of the following signal words and be alert to the
potential for personal injury:
warns about hazards that will cause
serious personal injury, death or major property
damage if ignored.
warns about hazards that will or can
cause serious personal injury, death or major property
damage if ignored.
warns about hazards that will or can
cause minor personal injury or property damage if
ignored.
The label NOTICE indicates special instructions which
are important but not related to hazards.
Carefully read and follow all safety instructions in
this manual and on pump.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
California Proposition 65 Warning
This product and related accessories
contain chemicals known to the State of California to
cause cancer, birth defects or other reproductive harm.
LOCATION:
Locate the pump as near to the water source as
practical. Make the suction pipe run short and straight
with as few pipe fittings as possible to keep total friction
loss to a minimum.
Install pump in a clean, dry and well drained location
if possible and protect against moisture and adverse
weather conditions. Pump should be located on a level,
hard surface to prevent shifting or tipping. Locate to be
readily accessible for inspection and maintenance.
Careful attention should be taken to assure that Net
Positive Suction Head Available (NPSHA) exceeds Net
Positive Suction Head Required (NPSHR) by the pump
or reduced performance and severe pump damage may
result.
Figure 1, Page 4, illustrates where these terms (NPSHA
/ NPSHR) come from, and how to determine if the
pumping conditions at which you want to operate meet
the proper criteria. When in doubt, consult your nearest
Berkeley Professional Dealer.
NOTE: If pump site is 1000 feet above sea level,
sub-tract 1.2 feet from the NPSHA equation and an
additional 1.2 feet for each additional 1000 feet of
elevation.
Page 3