TechniSat TechniVision 22 HD Manuel De Demarrage Rapide page 6

Important note
Remote control
2 Please read this first
Dear customer,
This quick start manual simply describes the most important connection options and the
basic operating steps required for you to quickly get started operating the TechniVision 22,
TechniVision 26 or TechniVision 32.
3 Remote control
3.1 Changing the battery
> Open the cover on the battery compartment at the rear of the remote control by
pushing it in the direction of the arrow and then lifting it off.
> Insert the supplied batteries, ensuring that the poles are the right way around (indicator
visible in battery compartment).
> Close the battery compartment again.
3.2 Remote control code
By switching over the remote control option it is possible to use this remote control to
operate a TechniSat television and two TechniSat receivers using the same coding.
Hold down the remote control code button to switch over the remote control option
>
and press the OK button as often as necessary until the LED for the desired remote
control option (TV, SAT1 or SAT2) flashes briefly.
The currently set remote control code will be displayed, as the appropriate LED
flashes, while pressing a button.
6