TechniSat TechniVision 22 HD Manuel De Demarrage Rapide page 12

Basic operation
5.3 Accepting settings / Exiting menus and functions
In some menus and functions the changes made must be accepted manually in order to
save them permanently. If this does not happen, the values that existed before leaving the
menu or the function will be reset automatically.
If an Accept field or the green function key with Accept is displayed in the bottom
line of the screen, you can see that the changes made must be saved manually to
be accepted.
By highlighting Accept using the right/left arrow keys and confirming with the
>
OK button or by pressing on the green function key (Accept), the changes are
saved and you return to the next menu level up.
Alternatively:
Press the Back button.
>
A request appears asking whether the changes you made should be applied.
Use the right /left arrow keys to highlight Yes or No and confirm with the OK
>
button.
According to your selection the changes are now saved or rejected and you return to
the next menu level up.
Alternatively:
Press the Menu button to leave the menu directly.
>
The settings that need to be saved manually will be reset in this case.
If the green function key with Accept is not displayed in the bottom line of the
screen, the changes are saved automatically when leaving the menu.
5.4 Changing a setting
You can create settings using the arrow selection method, the selection list, by
entering numbers and by using the virtual keyboard. The television dictates the
method that can be used to alter a marked setting. You can see this from the following
displayed symbols:
Arrow selection method (Point 5.4.1)
-
Arrows are shown on the left or right edge of the marking.
Selection list (Point 5.4.2)
-
The symbol is shown on the right edge of the marking.
Entering numbers (Point 5.4.3)
-
Virtual keyboard (Point 5.4.4)
-
The symbol is shown on the right edge of the highlight.
12