Canton Digital Movie Notice D'utilisation page 48

The DM System has too much upper bass
The DM System has too little or too much level in the
whole bass range
The DM System sounds "flat" (too little treble)
The DM System sounds sharp or aggressive (too much treble)
The sound signal sounds (very) distorted
1. The DM System is in a poor acoustic location
2. Equalisers have been set in the "Room Comp" menu
(volume level increase)
3. The bass level in the "Tone Control" menu is neutral or
1. The volume level adjustment for the subwoofer is set wrong
1. The listening area has severely dampened acoustics or the treble
sound setting is set very low
2. A pure stereo signal is being played in one of the surround modes 2. Set the DM System to stereo play mode
3. Equalisers have been set in the "Room Comp" menu
(volume level increase)
1. The listening area is acoustically hard (less dampened) or the
treble sound setting is too high
2. Equalisers have been set in the "Room Comp" menu
(volume level increase)
1. Listening at very high volume, which leads to overmodulation
of the DM System
2. Use of an analog input with a signal level that is too high (level
of the source is higher than 2Veff)
3. Use of Line2 / Phono input with a Line-level source and the
"Phono" setting
4. Use of Zone2 – Output to operate an external device with a
level that is set too high
5. With multi-channel recordings it is theoretically possible that
the signal processor of the DM System will be overmodulated
48
1. Where possible, set up the system in a different position (e.g.
closer to the wall)
2. Correct or delete the settings for the room adjustment (m =>
Speaker Menü => Room Comp => subwoofer)
3. Decrease the bass – level in the Sound Regulation menu
(m => Speaker Menü => Tone Control => Bass)
1. In the Speaker Menu (m => Speaker Menu =>
Level Trim =>subwoofer) set the desired volume level
for the subwoofer
1. Increase the treble setting in the sound settings menu (m =>
Speaker Menü => Tone Control => treble )
3. Correct or delete the settings for the room adjustment (m =>
Speaker Menü => Room Comp => front)
1. Decrease the treble setting in the sound settings menu (m =>
Speaker Menü => Tone Control => treble)
2. Correct or delete the settings for the room adjustment (m =>
Speaker Menü => Room Comp => front)
1. Immediately reduce the volume (also to avoid damaging the
device)
2. Decrease the level of the source if this has a volume control
3. Set the Line 2 /Phono – Input to "line" at "line2 config" (m
=> System Setup => factory set => line2 config)
4. Reduce the volume for the Zone2 – Output using the Volume
menu (m => System Setup => Output Config =>
zone2 vol)
5. Set the "dynamic" to "comp" (m => System Setup =>
dynamic)