Canton Digital Movie Notice D'utilisation page 44

Troubleshooting and Optimisation
Remote control (abbreviation: RC)
Description of problem
The RC display is blank
The RC keeps showing "Welcome CANTON", "Good bye
CANTON" or "please wait"
The RC shows "no connection"
Display on the RC is hard to read
The display is in the "wrong" language
(German and English are the 2 options)
The RC jumps from IR mode into DM System mode
In IR mode commands are carried out 2x
IR device is not operating (correctly)
Possible cause(s)
1. The RC is in idle mode
2. The batteries are missing or wrongly inserted
3. The batteries are "empty"
1. The RC processor has crashed
2. The DM System processor has crashed
1. The DM System is not ready
2. The distance between the DM System and the RC is too great
3. The DM System processor or the RC processor has crashed
4. The RC is not registered with the DM System
1. Poor contrast setting
1. The display language of the RC has been switched
2. The language of the DM System has been switched
1. The batteries are almost "empty"
1. When programming the code the key on the original RC was
pressed for too long
2. The key on the DM – RC was pressed for too long
1. The device has not been correctly programmed
2. The distance between the RCs was too great / too short
3. The code of the original RC cannot be programmed
44
Solution
1. Press any key to activate the RC
2. Insert the batteries correctly (+/-)
3. Insert new batteries correctly (+/-) or charge rechargeable
batteries
1. Remove a battery from the RC for min. 30 minutes then re-
insert correctly
2. Switch the DM System off at the mains for min. 30 minutes
then switch it back on
1. Connect the DM System to the mains power supply and / or
switch it "ON"
2. Reduce the distance to less than 10 m
3. Turn the DM System off at the mains for min. 30 minutes
then turn it back on and / or remove a battery from the RC
for min. 30 minutes then re-insert correctly
4. Register the DM System following the instructions on page
43 (Register your Remote Control with a DM System)
1. Press the "0" and "4" keys simultaneously until "kontrast
xx" is displayed and use "<" or ">" to adjust the contrast.
Press "exit" to close the window
1. Press the "5" and "9" keys simultaneously until "language"
is displayed and use the function keys to select the desired
language (display)
2. In the "System Menu" (m = > System Menu => factory set
=> language) select the desired language
1. Insert new batteries correctly (+/-) or charge rechargeable
batteries
1. When programming the function only press the key on the
original RC for a (very) short time
2. Only press the key on the DM – RC for a very short time
1. Repeat the programming process for the Canton RC with the
original RC of the IR device
2. Ensure a distance of approx. 5 cm between the RCs when
programming
3. Due to the wide range of devices on the market it can
happen that codes cannot be programmed. Unfortunately
this problem has no solution