Canton Digital Movie Notice D'utilisation page 47

In Surround Mode the voices are hard to understand
The DM System has little or no low bass
The DM System has too much low bass
The DM System has too little top bass
1. During recording (BD or DVD) the voices were mixed
between the right and left channels
2. The DM System is in 5.1 mode
1. Listening at a (very) low volume
2. The output for an external subwoofer is activated but no
subwoofer has been connected or is operating
3. The DM System is in a poor acoustic location
4. Equalisers have been set in the "Room Comp" menu
(volume level increase)
1. Listening at a high volume and activating the "Bass expand"
2. Using an external subwoofer with too high a level
3. The DM System is in a poor acoustic location
4. Equalisers have been set in the "Room Comp" menu
(volume level increase)
1. The DM System is in a poor acoustic location
2. Equalisers have been set in the "Room Comp" menu
(volume level increase)
3. The bass level in the "Tone Control" menu is set to neutral
or reduced
4. Use of an external subwoofer with the wrong phasing (phase
adjustment) between internal and external subwoofers
47
1. Select "surround 2" as Play Mode
2. Set the system to a 2.1 or 4.1 Mode at "System Preset"
(m => System Setup => factory setup => System Preset)
1. Set "Bass expand" (m => Speaker Setup => Bass
expand) to "low" or "high"
2. Deactivate the output for an external subwoofer at "Sub
Output" (m => System Menu => Sub Output) or connect it
to an operational external subwoofer using Sub-Out
3. Where possible, set up the system in a different position (e.g.
closer to the wall)
4. Correct or delete the settings for the room adjustment (m =>
Speaker Menü => Room Comp => subwoofer)
1. Set "Bass expand" (m => Speaker Setup => Bass
expand) to "low" or "off"
2. Adjust the external subwoofer (to a lower level)
3. Where possible, set up the system in a different position (e.g.
closer to the wall)
4. Correct or delete the settings for the room adjustment (m =>
Speaker Menü => Room Comp => subwoofer)
1. Where possible, set up the system in a different position (e.g.
closer to the wall)
2. Correct or delete the settings for the room adjustment (m =>
Speaker Menü => Room Comp => subwoofer)
3. Increase the bass level in the Sound Regulation menu (m =>
Speaker Menü => Tone Control => Bass)
4. Correct the phasing on the external subwoofer to suit the
DM internal subwoofer or change the position of the
external subwoofer