Canton Digital Movie Notice D'utilisation page 46

DM System -> Volume
No (music) playback
Volume will not go above a certain value (</=99)
DM System is quieter when switched on than when switched off
The balance is wrong (location is not central)
DM System – Sound
In Surround Mode there is little or no surround sound
1. The DM System is switched off or in Standby mode
2. The volume is set low or on mute
3. The wrong input has been selected
4. The signal (data stream) from the source has not been
recognised by the DM System
5. Wrong setting of Line2 / Phono input when using a
record player
1. The "max volume" is set to the maximum possible value
1. The "start volume" is set to a value that is lower than
the volume set before switching off
1. The volume adjustment of the satellite speakers is wrongly set
or the listening spot is not central
1. The Play Mode is set on "stereo" or "wide"
2. The listening spot is not central enough
3. The source only supplies a 2-channel signal
4. The DM System is set to 4.1/5.1 mode
46
1. Switch the DM System on so that the RC displays the main
screen
2. Use Volume + (V+) to increase the volume
3. Select the input that is connected to the relevant source
4. Set the source to a different data format or select another
audio format during playback (referring to the instructions of
the source device)
5. Set Line 2 / Phono – Input "line2 config" to "phono" (m
=>System Setup => factory set => line2 config)
1. Set the volume limiter (m => System Setup => factory set =>
max volume) to the desired value (max. 99)
1. Set the "start volume" (m => System Setup => factory
set => start volume) to the desired value (max. 99 but
not higher than "max volume")
1. In the Loudspeaker Menu use (m => Speaker Setup =>
Level Trim) to set the correct volume levels and (m =>
Speaker Setup => Speaker Distance) to set the correct
distances
1. Set Play Modes to "surround 1" or "surround 2"
2. In the Loudspeaker Menu use (m => Speaker Setup =>
Level Trim) to set the correct volume levels and
(m => Speaker Setup => Speaker Distance) to set the correct
distances to the listening spot
3. To achieve optimal sound in the room the DM System
requires a multi-channel data stream. In this case the RC
displays "virtual Dolby Digital" or "virtual DTS". All other
displays (e.g. "Virtual Dolby PLII) mean that it is not a multi-
channel data stream, which leads to less of a surround sound
impression
4. Set the system to a 2.1 Mode with virtual surround-mode at
"System Preset" (m => System Setup => factory setup =>
System Preset)