Canton Digital Movie Notice D'utilisation page 43

Register your remote control with a DM System
To register the remote control on a (further) DM System open the Programme Menu by pressing and simultaneously. Select "RF Learn"
and confirm this with . Select "new device" to register a DM System on the remote control. After confirmation you will be asked to connect
the DM System to be programmed to the mains power supply and to switch it on. Before doing this you should ensure that the DM System had been
disconnected from the mains power supply for at least 1 minute. The remote control will now try to connect with the newly activated DM System. A
successful connection will be shown in the display as "Installation successful", while failure will bring the message "Installation failed". If the connec-
tion has failed you should identify the problem (device not switched on, distance too great, DM System not disconnected from the mains power supply
for long enough, etc) and start the process again. After successful installation you must enter a name for the DM System. If you enter a name (e.g. DM
90) more than once the remote control will automatically allocate it a subscript (e.g. DM90.1, DM 90.2 ...). You can then exit the "RF-Learn" menu by
pressing twice.
If you wish to overwrite an existing DM System, instead of selecting "new device" you should select the system you wish to replace and confirm your
selection with . Select the "Learn" function to proceed. Confirm the overwriting with the "yes" function key or abort the process with "no".
Continue as previously described under "new device".
De-register your remote control from a DM System
To de-register your remote control from a DM System open the Programme Menu by pressing the and simultaneously, select "RF Learn"
and confirm with . Select the system you wish to "delete" and confirm your selection with . Select and confirm the "Clear" function to
continue. Complete the de-registration process by pressing the "yes" function key or abort the process with "no".
43