Charge With Elvi - EVBOX Elvi Manuel D'utilisation

Charge with Elvi

Start charging
1. Plug your charging cable into Elvi.
2. To start and stop a charging session, you can use a registered charge card, key
fob, or your mobile Elvi station management application.
3. In case of charge card activation, hold your charge card (RFID Card) in front of
the reader, marked with
4. Elvi reacts with a beep. This means that your card is being authorized.
5. The Elvi LED ring turns blue when it starts charging.
Stop charging
1. In case of charge card activation, hold your charge card (RFID Card) in front of
the reader, marked with
2. Elvi reacts with a beep. This means that your charge card/key fob is being
authorized. The Elvi LED ring turns green when it stops charging.
3. Unplug your charging cable from Elvi and place it back into your car.
Alternatively, you can unplug your charging cable from Elvi directly and end
your session.
What you see
LED ring off
or green
LED ring
green, flashing
LED ring
yellow
LED ring
yellow, flashing
LED ring
blue
LED ring
red
LED ring
red, flashing
icon.
icon.
What it means
Elvi is ready for use.
Your charge card is being
verified.
The car is fully charged.
Charging session is in queue
(applicable in the Smart
Charging environment only).
Elvi is charging the car.
Elvi is experiencing
an error.
Your charge card is not
authorized to charge.
What to do
Plug the charging cable into Elvi.
Wait until LED ring turns blue.
Unplug the charging cable from Elvi and place it
back into your car.
When power becomes available, charging will
start or resume, and the LED ring will turn blue.
The car is charging.
Check the troubleshooting chapter in this manual
for solutions. If this does not solve the issue, con-
tact your installer or supplier of Elvi, or write us at
support@evbox.com.
Contact your charge card service
operator.
EN
6