Charge With Elvi - EVBOX Elvi Manuel D'utilisation

EN

Charge with Elvi

Warning: Always perform a visual inspection for damage before starting a
charging session. Check that the contact area of the charging plug is free from dirt
and moisture; check the charging cable for cuts or abrasions to the insulation and
check the charging cable plug of Elvi for firm seat.
Start charging
1. Plug the Elvi charging cable into your car. If you're using a cable dock (optional)
and a Type 1 cable, press the release button on the cable plug, then release
the cable from the dock, and plug the cable into your car.
2. To start and stop a charging session, you can use a registered charge card, key
fob, or your mobile Elvi station management application.
3. In case of charge card activation, hold your charge card (RFID card) in front of
the reader, marked with
4. Elvi reacts with a beep. This means that your card is being authorized.
5. The Elvi LED ring turns blue when it starts charging.
Stop charging
1. In case of charge card activation, hold your charge card (RFID card) in front of
the reader, marked with
2. Elvi reacts with a beep. This means that your charge card / keyfob is being
authorized. Elvi LED ring turns green when it stops charging.
3. Unplug the Elvi charging cable from your car and place the charging cable
back into Elvi's cable holder. Alternatively you can unplug your charging cable
from your car directly and end your session.
What you see
LED ring off
or green
LED ring
green flashing
LED ring
yellow
LED ring
yellow flashing
LED ring
blue
LED ring
red
LED ring
red flashing
13
icon.
icon.
What it means
Elvi is ready for use.
Your charge card is being
verified.
The car is fully charged.
Charging session is in
queue, optionally in Smart
Charging environment
Elvi is charging the car.
Elvi is experiencing
an error.
Your charge card is not
authorized to charge.
What to do
Plug Elvi charging cable into the car.
Wait until LED ring turns blue.
Unplug Elvi charging cable from the car and
place the cable back into Elvi cable holder.
When power becomes available,
charging will start or resume,
and the LED ring will turn blue.
The car is charging.
Check the troubleshooting chapter in this
manual for solutions. If this does not solve the
issue, contact your installer or supplier of Elvi, or
message us at help@evbox.com.
Contact your charge card service
operator.