Before Use - Hitachi DB 3DL2 Instructions De Sécurité Et Mode D'emploi

Masquer les pouces Voir aussi pour DB 3DL2:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

NOTE
The
battery
charging
longer when a temperature is low or the
voltage of the power source is too low.
When the pilot lamp does not go off even if
more than four hour has passed after start of
the charging, stop the charging and contact
your
HITACHI
CENTER.
○ Regarding the temperature of the rechargeable
battery.
The temperatures for rechargeable batteries
are as shown in the table below, and batteries
that have become hot should be cooled for a
while before being recharged.
Table 2
Rechargeable
batteries
EBM315
○ Regarding recharging time
Table 3 shows the recharging time required
according to the type of battery.
Table 3 Recharging time (approx. min.) at 68°F
(20°C)
Battery
voltage (V)
3.6
EBM315
NOTE
The recharging time may vary according to the
ambient temperature and the power supply
voltage.
4. Disconnect
battery
receptacle.
CAUTION
Do not pull the plug out of the receptacle
by pulling on the cord.
Make sure to grasp the plug when removing
from receptacle to avoid damaging cord.
5. Remove the battery from the battery charger.
Supporting the battery charger with hand, pull
out the battery from the battery charger.
time
becomes
AUTHORIZED
SERVICE
Temperature at which the
battery can be recharged
32°F — 122°F
(0°C — 50°C)
Battery capacity (Ah)
1.5 Ah
30 min.
charger
from
Regarding electric discharge in case of new
batteries, etc.
As the internal chemical substances of new
batteries and batteries that have not been
used for an extended period is not activated,
the electric discharge might be low when using
them for the fi rst and second times. This is
a temporary phenomenon, and normal time
required for recharging will be restored by
recharging the batteries 2 – 3 times.
How to make the batteries perform longer.
○ Recharge the batteries before they become
completely exhausted.
When you feel that the power of the tool
becomes weaker, stop using the tool and
recharge its battery. If you continue to use the
tool and exhaust the electric current, the battery
may be damaged and its life will become
shorter.
○ Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately
after use. If such a battery is recharged
immediately after use, its internal chemical
substance will deteriorate, and the battery life
will be shortened. Leave the battery for a while
and recharge it after it has cooled.
CAUTION
● When
the
continuously used, the battery charger
will be heated, thus constituting the cause
of failures. Once the charging has been
completed, give 15 minutes rest until the
next charging.
● If the battery is recharged when it is warm
the
due to battery use or exposure to sunlight,
the pilot lamp may not light.
The battery will not be recharged. In such a
case, let the battery cool before charging.
● If the battery charger does not work while
the battery is mounted correctly, it is
probable that the battery or charger is
malfunctioning. Take it to your authorized
Service Center.

BEFORE USE

Check the work area to make sure that it is clear of
debris and clutter.
Clear the area of unnecessary personnel. Ensure
that lighting and ventilation is adequate.
English
battery
charger
has
been
13

Publicité

Table des Matières
loading

Table des Matières