After You Have Finished Using Your Appliance - SilverCrest SKM 650 A1 Mode D'emploi

–
Fit the kneading hook 0, whisk q or
beater w (referred to in the following as
"the attachment") to the drive shaft 7 in
such a way that the two metal pins on the
drive shaft 7 engage in the recesses of the
attachment 0 q w .
–
Push the attachment 0 q w firmly onto the
drive shaft 7 so that the spring compresses,
and rotate the attachment 0 q w anti-
clockwise a little way (towards
–
Let go of the attachment 0 q w . It is
now sitting firmly on the drive shaft 7 .
5) Put the ingredients into the mixing bowl 6,
observing the following table with the recom-
mended filling quantities:
Filling quantities for . . .
Yeast dough
Cake mixture
Heavy dough
(e .g . shortcrust pastry)
Cream
Egg white
(weight class M)
Adapt the remaining ingredients in the recipe to
the respective maximum quantity .
CAUTION! PROPERTY DAMAGE!
► Do not exceed the specified maximum filling
quantities!
Otherwise the appliance will be overloaded .
► If the appliance is labouring: Switch off the
appliance, remove half of the dough and
knead each half separately .
■ 18 │ GB │ IE
) .
min . max .
500 g
N/A
flour
400 g
N/A
flour
400 g
N/A
flour
200 ml 1000 ml
2 12
NOTE
► Please note that during the kneading or stirring
process, the mixture in the mixing bowl 6
increases in volume or is pressed upward
slightly as a result of the movement . You
should therefore never fill the mixing bowl 6
right up to the top!
6) Press the release button 2
swivel arm 1 with the mounted attachment 0
q w downwards into the working position .
NOTE
► If you wish, you can fit the filling accessory 8
onto the lid 9:
–
Press the filling accessory 8 into the
cut-out on the lid 9 .
Now you can add ingredients even during
operation .
7) Push the lid 9 onto the mixing bowl 6 .
8) Turn the rotary switch 3 to the required level
(see the section "Speed settings") .
After you have finished using your
appliance
1) Turn the appliance off using the rotary switch 3
(Position "OFF") .
2) Remove the lid 9 from the mixing bowl 6 .
3) Push the release button 2
swivel arm 1 to the highest position .
4) Remove the attachment 0 q w from the drive
shaft 7 by pushing the attachment 0 q w
against the drive shaft 7 and turning clock-
wise (direction
can remove the attachment 0 q w .
5) Remove the mixing bowl 6 by turning it anti-
clockwise and then pulling it upwards .
6) Clean the appliance (see section "Cleaning
and care") .
and press the
and move the
) at the same time . Then you
SKM 650 A1