Maintenance Of The Battery - Husqvarna Soff-Cut 2000 Manuel D'utilisation

14. Make sure that the belt tensioner moves freely up
and down.
15. Make sure that the belt tensioner bearings move
freely.
16. Assemble all parts in the opposite sequence to how
they were disassembled.
To lubricate the blade shaft bearings
The blade shaft bearings are below the product. To get
access, lift the product with the cutting depth handle.
1. Turn the ignition key to "ON" (1).
2. Pull the cutting depth handle in the direction of the
handlebar and lift the product to its full height.
3. Turn the ignition key to "OFF" (0).
4. Lubricate the blade shaft bearings with 3 pumps of
Lithium 12 based grease.
To adjust the transmission neutral
position
When you pull the forward speed lever to "STOP", the
product must fully stop. If the product moves, adjust the
transmission neutral position.
1. Loosen the locknut on the cable end at the
transmission.
793 - 001 - 19.04.2022
All manuals and user guides at all-guides.com
2. Pull the spring sleeve rearward and adjust the nut
until the product fully stops.
3. Tighten the locknut.
To examine the wheels
1. Regularly examine the wheels on your product.
Damaged wheels can decrease the quality of the
result.
2. Do a check that all wheels rotate freely and smooth.
3. Replace the wheels if they show signs of damage or
wear.

Maintenance of the battery

WARNING:
battery if you do not need to, it can cause
sparks and short circuits. A spark or flame
can cause a lead acid battery to explode.
WARNING:
not let metal objects touch the 2 battery
terminals. This can cause a short circuit of
the battery.
WARNING:
battery, remove metal bracelets, wristwatch
bands, rings etc. Always use gloves and
protective glasses or face shield when you
work with the battery.
The battery is maintenance free. If the battery ever
requires charging, use only a voltage regulated taper
current charger designed specifically for sealed lead
acid gel cell batteries rated at 2 amps or less. A
standard automotive, or any other type, battery charger
To not disconnect the
Risk of electrical shock. Do
Before you connect a
65