Husqvarna Soff-Cut 2000 Manuel D'utilisation page 57

4. Turn the 2 locking knobs counterclockwise and
remove the blade block guard.
5. Push down on the kerf guide to release the skid
plate.
6. Put the supplied blade wrench on the blade shaft
bolt in the blade block.
793 - 001 - 19.04.2022
All manuals and user guides at all-guides.com
7. Use the blade wrench to turn the blade shaft
counterclockwise while you push the locking pin. The
locking pin will drop down and lock the blade shaft.
8. Use the blade wrench to turn the blade shaft bolt
counterclockwise.
9. Remove the blade shaft bolt (A). Remove the outer
blade flange (B). Remove the blade (C) from the
blade shaft (D).
C
D
B
A
To install a cutting blade
WARNING:
with a rated speed value lower than that of
the product. The rated speed value of the
cutting blade is marked on the cutting blade,
and that of the product is marked on the
type plate.
CAUTION:
for defects such as damages, cracks, loss of
segments, warping, overheating, excessive
Do not use a cutting blade
Examine the cutting blade
57