Husqvarna Soff-Cut 2000 Manuel D'utilisation page 56

To examine the spark plug
CAUTION:
recommended spark plug type. Incorrect
spark plug type can cause damage to the
product.
• For more information, refer to the operator's manual
for the engine.
To clean the product externally
CAUTION:
immediately after use, before the concrete
becomes dry. Remaining concrete can
cause damage to the product.
1. Remove the blade. Refer to
blade on page 56 .
2. Clean the product with water.
CAUTION:
directly at the engine, especially if you
use a high-pressure washer.
3. Make sure that the handles and levers are clean and
dry before you operate the product.
4. Clean the blade block and blade from concrete
particles after each use. Use a heavy duty brush and
water. The remaining concrete (A) will dry and set
(B) if you do not remove it.
A B
5. Keep all openings and slots on the product clean
to make sure that air flows freely through the motor
area.
To do a general inspection
• Make sure that the nuts and screws on the product
are tightened.
56
All manuals and user guides at all-guides.com
Always use the
Always clean the product
To remove the cutting
Do not point the water
• Make sure that there are no fuel or oil leaks.
• : Make sure that the wheels for the front guide and
the rear guide turn freely.
To do a check of the ignition key
1. Make sure that the engine starts and that the blade
starts to rotate when you turn the ignition key to
"ON" (1).
2. Make sure that the engine stops immediately when
you turn the ignition key to "OFF" (0).
To remove the cutting blade
1. Turn the ignition key to "ON" (1).
2. Pull the cutting depth handle in the direction of the
handlebar and lift the product to its full height.
3. Turn the ignition key to "OFF" (0).
793 - 001 - 19.04.2022