Sony AC-120MD Instructions D'utilisation page 13

If in doubt, consult the qualified service personnel.
3. The leakage current could increase when connected
to other equipment.
4. This equipment generates, uses, and can radiate
radio frequency energy. If it is not installed and used
in accordance with the instruction manual, it may
cause interference to other equipment. If this unit
Important EMC notices for use in the medical environments
 The AC-120MD needs special precautions regarding EMC and needs to be installed and put into service according to
the EMC information provided in the instructions for use.
 The portable and mobile RF communications equipment such as cellular phones can affect the AC-120MD.
Warning
The use of accessories and cables other than those specified, with the exception of replacement parts sold by Sony
Corporation, may result in increased emissions or decreased immunity of the AC-120MD.
Guidance and manufacturer's declaration-electromagnetic emissions
The AC-120MD is intended for use in the electromagnetic environment specified below.
The customer or the user of the AC-120MD should assure that it is used in such an environment.
Emission test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Warning
If the AC-120MD should be used adjacent to or stacked with other equipment, it should be observed to verify normal
operation in the configuration in which it will be used.
Consult your dealer. (According to standard IEC 60601-
1-2 and CISPR11, Class B, Group 1)
Compliance
The AC-120MD uses RF energy only for its internal function.
Group 1 Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.
The AC-120MD is suitable for use in all establishments,
Class B including domestic establishments and those directly connected
to the public low-voltage power supply network that supplies
buildings used for domestic purposes.
Class D
Complies
causes interference (which can be determined by
unplugging the power cord from the unit), try these
measures: Relocate the unit with respect to the
susceptible equipment. Plug this unit and the
susceptible equipment into different branch circuit.
Electromagnetic environment-guidance
3
GB