Publicité
Les langues disponibles
Les langues disponibles
GB
folk
7
Opening the box
Open the box 1, take out the chassis 2 and the hood 3, the armrest 4, the front wheels 5, the rear
wheels 6, the cup holder 7.
8
Unfolding the pushchair
First, unfasten the clip as shown in Figure 1.
Lift the handlebar upwards as shown in Figure 2 until you hear it click indicating that the chassis
is unfolded.
Note: Make sure the chassis is locked into place before use.
9
Unfolding the seat
Hold the backrest adjustment device with one hand as shown in Figure 1, then move the backrest
upwards as shown in Figure 2, until the seat is fully opened.
10
Fitting the hood / Fitting the cup holder
Note: Maximum weight: 0.5 kg. Do not overload
Fitting the hood: Insert the hooks on both sides of the chassis into the corresponding slots.
Fitting the cup holder: Insert the cup holder into its position on the edge of the handlebar, in the
direction of the arrow. To remove it, pull it upwards and take it off.
11
Fitting/removing the front wheels
Fitting: Insert the front wheel into the front wheel bracket and make sure it clicks into place.
Removing: Press the front wheel release button and pull the wheel downwards.
12
Fitting/removing the rear wheels
Fitting: Insert the rear wheel into the rear wheel bracket and make sure it clicks into place.
Removing: Press the rear wheel release button, then take the wheel off.
13
Fitting/removing the armrest
Fitting: Insert the armrest in the direction of the arrow into the fixed position on the inside of the
chassis and make sure it clicks locked into place.
Removing: Press the release button on both sides at the same time and take the armrest off.
14
Using the hood
Adjusting the hood: Push the hood forwards or backwards to open and close it as shown in the
diagram above.
Opening the window: Unfasten the zip to open the window.
15
Adjusting the footrest
Adjusting the footrest: Press down on both sides of the footrest as shown in the diagram on the
right to adjust the angle.
16
ADJUST THE SEAT BELTS TO FIT THE CHILDREN WHENEVER THEY USE THE PUSHCHAIR
The two side fastening points of the seats can be used to attach an additional harness. Your
pushchair is approved for new born babies. To fit the belts on your baby when he is under
6 months old, pass the shoulder straps through the lower holes and fasten the shoulder protector
pads using the Velcro. When your child is over 6 months old, pass the straps through the holes
that are most comfortable for the child.
17
Publicité
