Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Indicator
Error
Warning: There is a hot pot in the
"†
and the heat
area of the control panel. There is a
setting flash alter-
risk that the electronics will overheat.
nately. An audible
signal can be
heard
There is a hot pot in the area of the
and audible
"†
control panel. To protect the elec-
signal
tronics, the cooking zone has been
switched off.
The cooking zone was in operation
"‰
for too long and has switched itself
off.
Notes
The cooktop regulates the heating element
▯
temperature by turning the heat source on and off; this
means that the reddish glow of the heat source
beneath the heating element may not always be
visible. If you select a low heat setting, the heat source
is frequently off; at higher settings it is seldom off. The
source turns on and off even at the highest settings.
You may hear a quiet hum when the heating elements
▯
are in the heating phase. The heating elements may
glow with different levels of brightness. Depending on
the angle from which you are looking at the heating
element, this glow may be visible over the marked
edge of the heating element. These are technical
characteristics. They have no effect on quality and
function.
Glass ceramic may have uneven areas on the surface
▯
due to the nature of the material itself. Because of the
mirror-like finish on the cooking surface, even
extremely small bubbles less than 1 mm in diameter
may be visible. These bubbles will not have any
adverse effect on the operation of the cooktop nor on
the durability of the glass ceramic cooking surface.
Depending on the countertop that is present in the
▯
kitchen, an uneven gap between the cooktop unit and
the countertop can occur. For this reason, a flexible
seal is provided around the entire cooktop unit.
Task
Remove the pot. The fault display goes out shortly after-
wards. You can continue cooking.
Remove the pot. Wait a while. Touch any control. When
goes out, you can continue cooking.
"†
You can switch the cooking zone back on again immedi-
ately.
Technical service
Contact our Technical Service Department if your
appliance needs repair. Our central Customer Service
Center (see below) will also be happy to supply you with
details on a center close to you.
E number and FD number:
When you contact our service, please have the Model(E)
number and the FD number for your appliance available.
You can find the identification plate with these numbers
on the underside of the appliance and in the appliance
booklet.
Questions? Please contact us. We look forward to
hearing from you!
17
Publicité
Table des Matières
Dépannage
