CAME GGT40AGS Manuel D'installation page 72

Photocell BUS <n>
Associate a function with the photocell BUS <n> input.
<n> is between 1 and 8 and corresponds to the address set on the photocell dip-switch
b1-b8
<Mode> BUS flashing beacon
Choose the operating mode for the BUS flashing beacon connected to the BUS terminal.
The function only appears if there is a BUS flashing beacon connected.
b40 >
<Opening colour> BUS flashing beacon
Set the BUS flashing beacon colour during operator opening.
The function only appears if there is a BUS flashing beacon connected.
During the count preceding automatic closure, the colour of the flashing beacon is the same as during opening.
b40 >
<Closing colour> BUS flashing beacon
Set the BUS flashing beacon colour during barrier closing.
The function only appears if there is a BUS flashing beacon connected.
b40 >
OFF (Default)
C1 = Reopen while closing (photocells)
C4 = Obstacle standby (photocells)
C5 = Immediate closure at the travel end during opening
C9 = Immediate closure at the travel end during opening with obstacle standby during closure
C10 = Immediate closure during opening with obstacle standby during closure (NO contact)
C13 = Reopening during closure with immediate stop once the obstacle has been removed, even with boom not in
movement
C23 = Open command
C24 = Close command
L1
L2
L3
0 =Flashing beacon (Default). The light flashes during opening and closing.
1 = Cycle flashing beacon. The light flashes during opening and closing and remains
on during the countdown before automatic closure.
The colour of the flash depends on the functions [L2], [L3] and [L4].
1 = White (Default)
2 = Yellow
3 = Orange
4 = Red
5 = Purple
6 = Blue
7 = Light blue
8 = Green
1 = White (Default)
2 = Yellow
3 = Orange
4 = Red
5 = Purple
6 = Blue
7 = Light blue
8 = Green