Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Remove all
Remove all registered users.
U3
Radio decoding
Choose the type of radio coding for the transmitters enabled to control the operator.
If you choose the type of radio coding for the transmitters [Rolling code] or [TW key block], any transmitters with a different type of radio coding saved
previously will be deleted.
U4
Self-Learning Rolling
Save a new rolling code transmitter by activating acquisition from a rolling code transmitter that has already been saved. The saving and acquisition procedures are
explained in the transmitter manual.
U8
Boom length
Set the boom length.
A1
Motor test
Check the boom opens in the correct direction.
If the keys do not execute the commands correctly, invert the boom opening direction.
A2
Travel calibration
Start the travel self-learning.
A3
Parameter reset
Restore the factory configurations except for: [users], [boom length], [CRP address], [RSE2 settings], [password] and the settings related to the travel calibration.
A4
OFF (Default)
ON
1 = All decoding (default)
2 = Rolling code
3 = TW key block
OFF (Default)
ON
3 = 3 m boom
4 = 4 m boom
6 = 6 m boom
8 = 8 m boom
The button > makes the motor turn in clockwise direction.
The button < makes the motor turn in an anticlockwise direction.
ON (Run operation)
OFF (Cancel operation)
OFF (Default)
ON
Publicité
Table des Matières
