CAME GGT40AGS Manuel D'installation page 48

Size
Cable types and minimum thicknesses
Cable length (m)
Power supply 230 V AC
Power supply 120 V AC
24 V AC/DC flashing beacon
TX Photocells
RX photocells
24 V DC electric lock
Command and control devices
* no. = see product assembly instructions - Warning: the cable cross-section is indicative and varies according to the motor power and cable length.
To connect the antenna, use RG58 cable (up to 5 m).
For installation in an outdoor environment, use cables with properties at least equivalent to those of type H05RN-F (with designation 60245 IEC 57).
For installation in an indoor environment, use cables with properties at least equivalent to those of type H05VV-F (designation to 60227 IEC 53).
If the cable lengths differ from those specified in the table, define the cable cross-sections according to the actual power draw of the connected devices
and in line with regulation CEI EN 60204-1.
For multiple, sequential loads along the same line, recalculate the values in the table according to the actual power draw and distances. For information
on connecting products not covered in this manual, please see the documentation accompanying the products themselves.
For paired and CRP connection, use a UTP CAT5 cable. Maximum length 1000 metres.
Single branch length (m)
BUS cable
The total length of all branches can be a maximum of 150 m.
The cable cannot be shielded.
Wind resistance
The table shows the boom wind-load resistance.
The value relates to the boom only and does not refer to any applicable accessories.
Resistance class with reference to the EN 13241 standard.
Type
Resistance class
Wind pressure [Pa]
Maximum wind speed [km/h]
max. 4000
3G x 1.5 mm²
3G x 1.5 mm²
2 x 1 mm²
2 x 0.5 mm²
4 x 0.5 mm²
2 x 1 mm²
*no. x 0.5 mm²
326
258
up to 20
Boom 3.2 m
5
1500
190
340
237
from 20 to 30
3G x 2.5 mm²
3G x 2.5 mm²
2 x 1 mm²
2 x 0.5 mm²
4 x 0.5 mm²
2 x 1 mm²
*no. x 0.5 mm²
max. 50 m
2 x 1 mm²
Boom 4.2 m
4
900
145
59
107