Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Hold-to-run
With the function active, the operator stops moving (opening or closing) when the control device is released.
When the function is active, it excludes all other control devices.
F6
Obstacle with motor stopped
With the function active and the operator stopped, an open or close command is not performed if the safety devices detect an obstacle.
F9
Open warning light
Barrier status signal.
The device is connected to output 10-5.
F10
Sensor type
Choose the type of access device.
F14
Electric lock
Choose the electric lock activation mode during boom manoeuvring.
F17
Light E1
Choose the type of device connected to output E1.
F18
Automatic closure
Set the time before automatic closure is activated, once the opening travel end point has been reached.
The function does not work if any of the safety devices are triggered when an obstacle is detected, or after a complete stop, or during a power outage.
F19
OFF (Default)
ON
OFF (Default)
ON
0 = Warning light on (default) - The light stays on when the boom is moving or open.
1 = Warning light flashing - The warning light flashes every half a second when the boom is opening and remains on when
the boom is open. The light flashes every second when the boom is closing, and remains off when the boom is closed.
1 = Keypad (Default)
0 = Transponder
OFF (Default)
1 = The electric lock is deactivated during barrier opening and remains deactivated until the barrier is closed again.
0 =Flashing beacon (Default)
1 = Cycle light
The lamp stays on during the manoeuvre.
The light remains off if an automatic closing time is not set.
2 = Courtesy lamp
The light switches on when a manoeuvre starts and remains on once the manoeuvre has finished, for the time set under the
function [F25 Courtesy time].
OFF (Default)
From 1 to 180 seconds
Publicité
Table des Matières
