koban KPA-01 MINI Mode D'emploi page 37

KPA-01 MINI
AC/DC TRUE RMS CLAMP METERAC/DC
WARNING: Risk of Electrocution. Before use, always test the
Voltage Detector on a
known live circuit to verify proper operation
1. Touch the probe tip to the hot conductor or insert into the hot
side of the electrical outlet.
2. If AC voltage is present, the detector light will illuminate.
NOTE: The conductors in electrical cord sets are often twisted.
For best results, rub the
probe tip along a length of the cord to assure placing the tip in
close proximity to the
live conductor.
NOTE: The detector is designed with high sensitivity. Static
electricity or other sources of
energy may randomly trip the sensor. This is normal operation
Flashlight
Press and hold the top button to turn the flashlight on. Release the
button to turn the flashlight
off.
Data Hold & Backlight button
To freeze the current reading on the LCD, press the "Data Hold &
Backlight" key. The
word HOLD will appear on the LCD while the meter is in the
Data Hold mode. To release the
Data Hold function and return the meter to normal operation, press
the "Hold Backlight" key
again. The word HOLD will switch off. The backlight function
illuminates the display and is used
when the ambient light to too low to permit viewing of the
displayed readings. Press the Data
Hold & Backlight button for 2 second to turn the backlight on and
press the button a
8 www.grupotemper.com