Parameter - JUMO Wtrans p Notice De Mise En Service

6 Setup program
6.5

Parameter

Parameters
Transmitter detection (transmit-
ter ID)
Transmission interval
Radio frequency
Offset
TAG number
Information text
Installation date
NOTE!
At a transmission interval of > 5 s, the transmitter transmits a link telegram (after a setup transmission),
i.e. the telegrams are transmitted at the factory-set interval of 5 s for a period of 30 minutes, and only
then at the set transmission interval.
NOTE!
If the setup connector is connected, the transmitter automatically transmits telegrams with a transmis-
sion interval of 0.5 s to enable the receiver to immediately detect changes. After the setup connector is
removed, the telegrams are transmitted again at the set transmission interval.
Term definition
Transmitter detection (transmitter ID)
The transmitter detection (transmitter ID) is a unique ID with max. 5 characters which is recognized by
the receiver. The ID can be individually changed, for example, to obtain a better plant overview. Ensure
that an ID is not used simultaneously by two transmitters within the reception range to avoid malfunc-
tions.
Transmission interval
This parameter defines the time intervals used to transmit data to a receiver. The setting of the "Trans-
mission interval" parameter affects the battery operating life. For this reason, exercise caution and do
not only consider the transmission quality when selecting the interval.
Radio frequency
The radio frequency defines the frequency band used to transmit data to a receiver. The radio frequency
is defined in Europe at 868.4 MHz.
32
Default setting
Deactivated
5 s
868.4 MHz
0 bar
Current date
Value range/selection
1 to 99999
0.5 to 3600 s
868.4 MHz
Display only, cannot be edited
-100 to +100 bar
20-digit number, freely selectable
40-digit number, freely selectable
Any date
