Configuring The Transmitter; Establishing The Communication; Extracting The Current Transmitter Parameters - JUMO Wtrans p Notice De Mise En Service

6 Setup program
6.4

Configuring the transmitter

This chapter explains how to configure a transmitter using the setup program. To do this, the transmitter
and the laptop/PC must be connected via a USB cable.
6.4.1

Establishing the communication

There are two different ways to establish the communication between the transmitter and setup program:
• Establish the communication with "Device settings assistant".
This is used if the setup program is being used for the first time
(device list is empty).
• Establish the communication without "Device settings assistant".
This is used if communication has previously been established between the receiver and/or trans-
mitter and the setup program (entries in the device list).
Establishing the communication using the Device settings assistant
1. Start the setup program.
2. Select the "Establish connection" function in the "Data transfer" menu.
The "Device settings assistant" appears.
3. Select the transmitter under the "Device version" and confirm by pressing "Next".
4. Exit the assistant by clicking "Finish".
The device list with the selected transmitter appears.
5. Click the "Connect" button.
The device list is closed, the assistant is exited, and the communication between transmitter and set-
up program is established.
Establishing the communication without the Device settings assistant
1. Start the setup program.
2. Select the "Establish connection" function in the "Data transfer" menu.
The device list containing all devices entered is displayed.
3. Left-click the desired transmitter to select it.
4. Click the "Connect" button.
The device list is closed, the assistant is exited, and the communication between transmitter and set-
up program is established.
6.4.2

Extracting the current transmitter parameters

1. In the "File" menu, select the "New" function.
The "Device assistant" starts.
2. Confirm the "User-defined setting" by clicking the "Next" button.
3. Select the "Frequency band" and confirm with "Next".
4. Select the receiver variant and confirm by clicking "Next".
5. Exit the overview of the selected settings by clicking "Finish".
The current settings are displayed in the setup program.
6. Select the desired transmitter from the navigation tree by left-clicking it.
7. In the "Data transfer" menu, select the "Data transfer from device" function.
8. Exit the "Save file" prompt by clicking "Skip".
30