Product Overview - Toro Power Plex 51136 Manuel De L'utilisateur

Setup
Note:
The battery pack is not fully charged when it
is purchased. Before using the tool for the first time,
refer to Charging the Battery Pack (page
Mounting the Battery
Charger (Optional)
If desired, mount the battery charger securely on a
wall using the wall-mount key holes on the back of
the unit.
Make sure to mount it indoors (such as a garage or
other dry place), near a power outlet, and out of the
reach of children.
Refer to Figure 1 for assistance in mounting the
charger.
Note:
Slide and twist the charger over the
appropriately positioned hardware to secure the
charger in place (hardware not included).
10).
Figure 1

Product Overview

Left Side of Hedge Trimmer
1. Blades
2. Guard
3. Auxiliary-handle switch
4. Auxiliary handle
5. Handle-rotation button
Specifications
Model
Cutting Length
Rated Voltage
No-load Speed
Cutting width
Charger Type
Battery Type
Weights
Mass of the machine without
the battery
Mass of the machine with
battery 88525
Mass of the machine with
battery 88526
Appropriate Temperature Ranges
g194202
Charge the battery at
Use products at
Store products at
Unplug the charger if
*Charging time will increase if you do not charge the
battery within this range.
Store the tool, battery pack and battery charger in an
enclosed clean, dry area.
8
Figure 2
6. Lock switch
7. Trigger
8. Battery latch
9. Battery pack
10. Protective cover
51136 51136T
610 mm 610 mm
40 VDC maximum; 36 VDC nominal
3000 dual action spm at 40V maximum
18 mm
88527
88525 (included with 51136), 88526
(sold separately)
3.6 kg (8.0 lb)
4.6 kg (10.2 lb)
5.2 kg (11.5 lb)
0°C (32°F) to 40°C (104°F)*
-15°C (5°F) to 60°C (140°F)
-15°C (5°F) to 60°C (140°F)
Below 0°C (32°F) or above
40°C (104°F)
g204357