10. Troubleshooting guide
Fault
Motor does not start
Motor performance
drops
Important note!
For protection, the motor is equipped with a thermal switch which cuts out when the motor is
overloaded and switches on again automatically after a short cooling period.
Possible causes
a) No power at the plug
b) Cable defective
c) Switch/plug block defective
d) Motor terminals or capacitor
disconnected
e) excessive working depth
a) Soil too hard
b) Blades badly worn
Remedy
a) Check the power cable and fuse
b) Check
c) By customer service workshop
d) By customer service workshop
e) Reduce working depth
a) Correct working depth
b) Replace hoe blades
GB
15