Laser Adjustment - DeWalt DW7187 Guide D'utilisation

Use of Miter Saw
Laser System
WARNING: Read all instructions
for the Installation of Laser Power
Supply and the Installation of Laser
before using the Miter Saw Laser
System.
NOTE: The machine must be connected to a power source.
The Miter Saw Laser System is equipped with an ON/OFF switch
(B). The Miter Saw Laser System is independent of the machine's
trigger switch.
Compound Miter and Sliding
Miter Saws

LASER ADJUSTMENT

1. Set the miter saw to 0˚ miter and 0˚ bevel. Cut the end of a
board up to 6" (152mm) wide to make end of board square
with fence.
NOTE: The wider the board, the more accurate the adjust-
ment must be.
2. To turn on the laser, press the
ON/OFF switch (B).
B
3. Insert the trigger lock (C) into the
miter saw until it snaps into
place. The trigger lock is secured
to the LPS.
Remove 2.5mm hex wrench (D)
for laser adjustments.
4
B
D
C
C