Handlebar Switches - Benelli Leoncino Manuel Du Propriétaire

Handlebar switches

Left
ABS
1. Horn switch " "
2. Dimmer/switch " / "
3. Turn signal switch " / "
4. Passing button
5. ABS switch
ABS
Right
4
2
5
3
1
1. Run/Start switch "
2. Hazard switch " "
3. Electric ignition button
Horn switch " "
Press this switch to sound the horn.
Dimmer/switch "
Set this switch to "
and to " " for the low beam.
Turn signal switch "
To signal a right-hand turn, push this swi-
tch to " ". To signal a left-hand turn,
push this switch to "
the switch returns to the center position.
To cancel the turn signal lights, push the
switch in after it has returned to the cen-
ter position.
3 - 7
Instrument and control functions
Passing button
Press this button (daytime) to enable la-
shing lights.
Run/Start switch " /
To crank the engine with the starter, set
1
this switch to " ", see page 5-1 for star-
ting instructions prior to starting the en-
2
gine.
3
Set this switch to " " to stop the engine in
case of an emergency, such as when the
vehicle overturns or when the throttle
/ " cable is stuck.
Hazard switch "
With the ignition key set to " " use this
switch to switch on the emergency lights
(simultaneous lashing of all of the di-
rection indicators).
The emergency lights are used in case of
/ " emergency, to advise the other road users
" for the high beam that your vehicle is about to stop in dan-
gerous trafic areas.
/ "
Do not use the emergency lights when
". When released,
the engine is off; this is to stop the bat-
tery from becoming flat.
"
"
WARNING
EN
3