Benelli Leoncino Manuel Du Propriétaire page 114

Digital clock setting
Push and hold the menu switch "SELECT"
for 3 seconds to enter the setting mode
"TOTAL KM".
Press and hold down the "SELECT" button
for 3 seconds until the reading begins to
lash.
Adjust the hour by pressing the"RESET"
button.
Press the "SELECT" button to pass on to
adjust the minutes. Adjust the minutes by
pressing the "RESET" button.
Press the "SELECT" button again to quit.
Fuel gauge
The digital fuel gauge shows the capacity
of the fuel tank. As the fuel level drops, the
lines on the gauge will become closer and
closer to the "E" reserve area.
As soon as the inal line starts to lash, there
is an autonomy of about 1.3 litres of fuel.
Speedometer
Push and hold the menu switch "SELECT"
for 3 seconds to enter the setting mode
"TOTAL KM".
Speedometers Indicates the vehicle's spe-
ed in km/h or mph. To pass from one to
the other, press the "RESET" button.
Total/partial kilometre counter
The total kilometre counter shows the to-
tal distance covered in kilometres.
Set in the mode instrumentation "TRIP A /
TRIP B" with the "SELECT" button.
The partial kilometre counter (TRIP A/TRIP
B) shows the distance covered since the
last reset in kilometres.
The partial kilometre counter can be used
to estimate the possible distance to cover
with a full tank of fuel. This information
may make it possible to schedule future
fuelling stops.
RESET/SELECT buttons
Buttons to set vehicle data.
Press the "SELECT" button to see the par-
tial or total kilometres.
When viewing partial kilometres (TRIP
A/ TRIP B), it is possible to reset them by
holding down the "RESET" button for 3
seconds.
Transmission gear display
The transmission gear display shows the
selected gear.
This model is equipped with 6 gears.
3 - 5
Instrument and control functions
Anti-lock Brake System (ABS) warning
light
1. ABS error: whenever any fault is de-
tected and saved, the ABS diagnostic light
is on.
The ABS diagnostic light will turn off with
the next SHUTDOWN/ IGNITION of the in-
strument panel or when the vehicle exce-
eds the speed of about 5 km/h.
2. Disabled ABS mode: the ABS diagno-
stic light will flash once for about 1.30 se-
conds (short flashing).
3. By keeping the ABS button pressed for a
time of 3/30 seconds, the ABS diagnostic
light will flash once for about 0.30 se-
conds (short flashing).
4. ABS activated: When the instrument
panel is on, the ABS diagnostic light will
be on until the vehicle reaches the speed
of about 5 km/h. Once having exceeded
this speed, the diagnostic light will turn
off.
EN
3