Overtime Order; Change The Passcode; Clear All Orders; Change The Maximum Order Time - Hatco Flav-R 2-Go F2G Série Manuel D'installation Et D'utilisation

OPERATION

Overtime Order

When an order is in the locker past the maximum order time,
the timer on the Select Lockers screen will turn red. The
customer will not be able to open the locker after the timer
expires. The customer will be notified to "Please see staff to
reorder!".
In order for the locker to be used for another order, the locker
must be cleared. Use the following procedure to reset an
overtime order.
1. Remove and discard food from locker.
2. Follow the "Clear a Single Order" procedure.
3. When the next order is ready, follow the "Placing an Order"
procedure.

Change the Passcode

1. On the Select Lockers screen, touch
2. Enter the Passcode and touch ENTER to access the
System Settings screen.
• The factory set Passcode is: 88888
88888
Passcode Screen
3. Touch SET PASSCODE.
NOTE: The CONFIGURATION selection on the System
Settings screen is for factory use only.
System Settings Screen
4. On the Set Passcode screen, enter the current passcode
and touch ENTER.
5. Enter the new password and touch ENTER.
6. Touch the

Clear All Orders

1. On the Select Lockers screen, touch
2. Enter the Passcode and touch ENTER to access the
3. Touch CLEAR ORDERS.
NOTE: The CONFIGURATION selection on the System
for system settings.
4. Touch the

Change the Maximum Order Time

1. On the Select Lockers screen, touch
2. Enter the Passcode and touch ENTER to access the
3. On the "Max. Order Time" line, touch the
4. Touch the
14
• The unit will notify the operator "Password successfully
changed".
to return to the Select Lockers screen.
System Settings screen.
• The factory set Passcode is: 88888
• All orders will be cleared on the Select Lockers screen.
Settings screen is for factory use only.
System Settings Screen
to return to the Select Lockers screen.
System Settings screen.
• The factory set Passcode is: 88888
to increase or decrease the maximum order time.
• The maximum order time changes in increments of 1
minute and can be set up to 45 minutes.
to return to the Select Lockers screen.
English
for system settings.
for system settings.
or arrow
Form No. F2GM-0820