Operation; General; Placing An Order - Hatco Flav-R 2-Go F2G Série Manuel D'installation Et D'utilisation

English

General

Use the following information and procedures to operate a
Hatco Flav-R 2-Go Locker System.
® ®
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
CAUTION
BURN HAZARD: Some exterior surfaces on unit will get
hot. Avoid unnecessary contact with unit.
Single-Sided Models
Single-sided models are equipped with one screen used by
both operators and customers. The default screen is the Order
Ready screen for customers. Touch the
passcode to switch/flip to the operator's Select Lockers screen.
The touchscreen will switch back automatically to the Order
Ready screen after 20 seconds of inactivity.
Startup
Use the following procedure to turn on the unit.
1. Move the Power I/O (on/off) switch to the I (on) position.
• The Power I/O (on/off) switch is located above the
operator's touchscreen controller on pass-through units
and next to the power cord on single-sided access units.
• The touchscreen, LED lights, and heating elements (if
enabled) will energize.
• After the software loads, the Select Lockers screen or
Orders Ready screen will appear, depending on the
controller.
Red text indicates
locker is overtime.
White text indicates
time food is
in locker.
Locker is
disabled.
Flip Icon
(Single-Sided
Models Only)
Description of Select Lockers Screen
CAUTION
BURN HAZARD: Some exterior surfaces on the unit will
get hot. Use caution when touching these areas.
2. Allow the heated lockers 30 minutes to reach operating
temperature.
• The factory setpoint temperature is 150°F.
3. Refer to the "Placing an Order" procedure to input
customer order information and place food into a locker.
Form No. F2GM-0820
Shutdown
1. Move the Power I/O (on/off) switch to the O (off) position
2. Perform the "Daily Cleaning" procedure in the
NOTE: If unit is shutdown with active orders, the orders will be
Placing an Order (Operator Side)
Use the following procedure to place a completed and packaged
customer order into a locker for holding.
1. On the Select Lockers screen, touch the desired open
icon and enter the
2. With the locker(s) selected, touch PLACE ORDER.
3. Type the name of the order and touch ENTER.
Order
Code
Locker is
heating.
Settings
Error
11
and allow the unit to cool completely.
MAINTENANCE section of this manual.
saved for when the unit is turned back on, but the timer
will be reset. To clear orders refer to the "Clear a Single
Order" procedure in this section.
locker number(s).
• Up to three lockers can be selected if the food order will
not fit in one locker.
Enter Name Screen

OPERATION

continued...