Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
48
Dismount the cutter bar as follows.
Install supports underneath the cutter bar if it is lifted
from the ground, and you intend to carry out work to the
machine.
- Place the machine on a level floor.
- Remove the securing plate (6).
- Untighten the nut M30 (7) by a few turns.
- Lift the cutter bar a few cms from the ground. Block the
hydraulics keeping the cutter bar from going down.
- Remove the nut (7) and the ring (8).
- Untighten the 5 bolts (14) at the bottom of the support and
remove the end plate (9).
- Slide the mower elements and intermediate spacers from
the connecting rod (3).
Assembly of the cutter bar takes place in the reversed order.
Mind the directions listed hereafter.
- Clean the centring rings (10) and the contact areas of the
mower elements and intermediate spacers.
- Make sure that there is no contamination between those
elements and spacers which were not dismounted (grease
the sides with Castrol Tarp).
- Fit the elements in the standard configuration of directions
of rotation (fig. A-2) or in a configuration at your choice
("S" model mower discs only).
• A RH rotation SPLENDIMO PC element can be identi-
fied as follows.
When the hub is turned to the right (R - fig. A-3) the
drive gear on the RH side will turn anti-clockwise
(viewed from the rear).
• A LH rotation element can be identified as follows.
When the hub is turned to the left (L - fig. A-3), the drive
gear on the RH side will also turn anti-clockwise.
Make sure that the mower discs are turned 90° in respect
!
of one another. If a unit can not be slid onto the drive
shaft in one go, its disc needs to be turned a semi-turn one
or several times until the unit can be placed.
- After disassembly of a disc, check the presence of the
O-ring (11) in the pressure piece.
Tighten the castellated nut (12) with a torque of 150-250
Nm (15-25 kgm) and secure it with a split pin. Make sure
that the split pin does not protrude above the pressure
piece.
Supplement A
SPLENDIMO 321PC -"N"
SPLENDIMO 321PC -"S"
L
R
A-2
A-3
Publicité
Table des Matières
