Detaching The Front Panel; Preparing The Remote Control; Initial Settings - Pioneer DEH-X6800BT Mode D'emploi

Detaching the front panel

Detach the front panel to prevent theft. Remove any cables and devices attached to the
front panel and turn off the unit before detaching it.
Detach
Important
• Avoid subjecting the front panel to excessive shock.
• Keep the front panel out of direct sunlight and high temperatures.
• Always store the detached front panel in a protective case or bag.

Preparing the remote control

Remove the insulation sheet before use.
How to replace the battery
Insert the CR2025 (3 V) battery with the plus (+) and
minus (–) poles orientated properly.
WARNING
• Keep the battery out of the reach of children. Should the battery be swallowed, consult a doctor
immediately.
• Do not expose the battery or remote control to excessive heat such as direct sunlight or fire.
CAUTION
• There is a potential danger of explosion if the battery is incorrectly replaced. When replacing the
battery, replace it with the same type.
• Do not handle or store the battery with metallic tools or objects.
Attach
• If the battery leaks, remove the battery and wipe the remote control completely clean. Then install a
new battery.
• When disposing of used batteries, please comply with governmental regulations or environmental
public institutions' rules that apply in your country/area.
• "Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate. (Applicable to California, U.S.A.)"
Important
• Do not store the remote control in high temperatures or direct sunlight.
• Do not let the remote control fall onto the floor, where it may become jammed under the brake or
accelerator pedal.
Setting the clock (CLOCK SET)
When you turn the ignition switch to ON after installation, [SET UP :YES] appears in the
display.
1
Press the M.C. dial.
The setup menu disappears after 30 seconds of no operation. If you prefer not to set
at this time, turn the M.C. dial to select [NO], then press to confirm.
2
Turn the M.C. dial to adjust the hour, then press to confirm.
The indicator moves to the minute setting automatically.
3
Turn the M.C. dial to adjust the minute, then press to confirm.
[QUIT] appears.
4
Turn the M.C. dial to select [YES], then press to confirm.
NOTES
• You can cancel the menu setting by pressing SRC/OFF.
• This setting can be made at any time. See page 17 for more details.
Canceling the demonstration display (DEMO OFF)
1
Press the M.C. dial to display the main menu.
2
Turn the M.C. dial to select [SYSTEM], then press to confirm.
3
Turn the M.C. dial to select [DEMO OFF], then press to confirm.
4
Turn the M.C. dial to select [YES], then press to confirm.

INITIAL settings

1
Press and hold SRC/OFF until the unit turns off.
5
En