Illumination Settings; Mixtrax Settings - Pioneer DEH-X6800BT Mode D'emploi

ILLUMINATION settings

Menu Item
COLOR (Not available for DEH-X4800BT/X4810BT)
[KEY COLOR], [DISP COLOR],
[BOTH COLOR]
DIM SETTING
[SYNC ILLUMI]*, [SYNC CLOCK],
[MANUAL]
* Not available for DEH-X4800BT/
X4810BT
BRIGHTNESS
[1] to [10]
PHONE COLOR (Not available for DEH-X4800BT/X4810BT/X3800S)
[FLASHING]
[FLASH FX1] to [FLASH FX6]
[OFF]
18
En
Description
Select color for the keys/display of the unit from
12 preset colors, [SCAN] or [CUSTOM]*.
• [SCAN]: Cycle through a variety of colors
automatically.
• [CUSTOM]*:
1 Press and hold the M.C. dial until the color
setting display appears.
2 Set the primary color (R (red)/G (green)/B
(blue)) and brightness level ([0] to [60]).
You cannot select a level below 10 for all three
of R (red), G (green), B (blue) at the same time.
You can also customize the preset colors. Select
one of the preset colors, then press and hold the
M.C. dial until the color setting display appears.
* The CUSTOM setting is only available for [KEY
COLOR] and [DISP COLOR].
Change the display brightness.
Change the display brightness.
The available setting ranges differ depending on
[DIM SETTING].
Select the key color when a call is received.
Applies the color set by [KEY COLOR].
Cycle through a variety of colors automatically.
No change in key color made.
Menu Item
ILLUMI FX (Not available for DEH-X4800BT/X4810BT)
[ON], [OFF]

MIXTRAX settings

Menu Item
SHORT PLAYBCK/SHORT MODE
[1.0 MIN], [1.5 MIN], [2.0 MIN],
[2.5 MIN], [3.0 MIN], [OFF]
FLASH AREA (Not available for DEH-X4800BT/X4810BT)
[KEY/DISPLAY], [KEY], [OFF]
FLASH PATTERN (Not available for DEH-X4800BT/X4810BT)
[SOUND LEVEL 1] to [SOUND LEVEL
6]
[LOW PASS 1] to [LOW PASS 6]
[RANDOM1]
[RANDOM2]
[RANDOM3]
Description
The illumination effect can be seen when:
– there is an incoming call
– you are on a phone call
– a CD is inserted/ejected
The illumination effect will activate when the
ACC power is turned on/off regardless of this
setting.
Description
Select the length of the playback time.
Select the area for the illumination effect.
When [OFF] is selected, the color set under the
ILLUMINATION settings (page 18) is used as the
display color.
Change the illumination effect according to
the sound and bass level.
The flash pattern changes according to the
sound level.
The flash pattern changes according to the
bass level.
The flash pattern changes randomly according
to the sound level mode and low pass mode.
The flash pattern changes randomly according
to the sound level mode.
The flash pattern changes randomly according
to the low pass mode.