Tecno-gaz europa B pro Mode D'emploi page 78

ENGLISH
16
Messages of error are emphasized through an Alfa-numerical code, consisting in a letter
and three numbers.
The "A" code is relative to alarms, irregularities of the autoclave, after having carried out
the remedy, if the problem persists it is necessary to request telephonic assistance.
If an alarm message is diplayed (code "A") the cycle is to be considered
aborted: it will be necessary to repeat all the preparation and sterilization
operations.
To reset alarms and errors hold down at the same time the buttons under the bar indicated
with Reset.
ERROR
A 001
Cycle interrupted by the user
A 101
Vacuum not archieved in 10 min.
Vacuum not maintained on the first phase of VACUUM
A 111
TEST
Vacuum not maintained on the second phase of
A 121
VACUUM TEST
A132
Error in the flow-meter operation
Pressure above the allowable limit during the water recall
A133
for the warmup phases
A 200
Error in the control of the EV operation
A 400
Error in the locking operation
A 401
Error in the locking operation
A 403
Error in the locking operation
A 405
Error in the locking operation
A 551
Pressure out of limit
36
MESSAGES OF ERRORS
CAUSE SOLUTION
Reset and restart the
system
Reset and restart the
system
Reset and restart the
system
Reset and restart the
system
Reset and restart the
system
Reset and restart the
system
Reset and restart the
system
Reset and restart the
system
Reset and restart the
system
Reset and restart the
system
Reset and restart the
system
Reset and restart the
system